Shock tool?
Moderator: Tec Team
- Run4lo
- Posts: 537
- Joined: January 9th, 2007, 4:01 pm
- Location: Goshen, IN
- Contact:
Shock tool?
I curse you Sean Leanard! I was talking to Sean at breakfast yesterday and was telling him I was changing my shocks. He asked if I had one of those shock tools for the fronts. I probably looked at him weird because I didn't know what he was talking about. Well now I do! Sure could of used one...
If there's a Rock, YO I'll crawl it!
Check out the looks while my JK devours it!
Rocks, rocks, baby!
IH8MUD OlllllllO IH8MUD
JOTM Jan. 07 & Sept 10 - MIGS
Check out the looks while my JK devours it!
Rocks, rocks, baby!
IH8MUD OlllllllO IH8MUD
JOTM Jan. 07 & Sept 10 - MIGS
- green50gt
- Posts: 1356
- Joined: January 16th, 2007, 10:08 pm
- Location: Goshen
Unless you want to keep them... I either just cut the tops off or crank on the shock a few times back and forth and bust them off. Also Channel locks on the top of the shock...to hold that ring thing...then buzz the nut off the stud. Everything is ghetto in my garage, don't have a correct tool for anything I dont think.
- Run4lo
- Posts: 537
- Joined: January 9th, 2007, 4:01 pm
- Location: Goshen, IN
- Contact:
- Swamp Thang
- MJC member
- Posts: 740
- Joined: November 13th, 2007, 9:45 pm
- Location: Elkhart, IN.
- Blue Rubi
- Posts: 92
- Joined: May 12th, 2007, 10:32 pm
- Location: North Liberty, IN
I'll keep that in mind we have to get shocks soonSwamp Thang wrote:Let me know if you snap off the rear bolts. Got a little bit of experience there.
Pete
'05 Rubicon Unlimited
4" Rough Country,33" BFG/TA, Bilsten Shocks, Rampage Recovery Rear Bumper W/Tire Carrier, 60" Black Box Fabrication Front Bumper W/Custom Tube work, Navigator Off Road Lights
/l ,[____],
l---L –0lllllll0-
()_) ()_)--o-)_)
'05 Rubicon Unlimited
4" Rough Country,33" BFG/TA, Bilsten Shocks, Rampage Recovery Rear Bumper W/Tire Carrier, 60" Black Box Fabrication Front Bumper W/Custom Tube work, Navigator Off Road Lights
/l ,[____],
l---L –0lllllll0-
()_) ()_)--o-)_)