I hacked my XJ!
Posted: July 12th, 2009, 4:04 pm
Not too shabby....boy was I nervous. Got a start on it....I'll finish this week.
Not too shabby....boy was I nervous. Got a start on it....I'll finish this week.Page 1 of 1
Not too shabby....boy was I nervous. Got a start on it....I'll finish this week.Posted: July 12th, 2009, 4:37 pm
Looks good you'll be ready for 35's in no time. Don't forget to fold over the pinch welds they will eat your tires in nothing flat.
Posted: July 12th, 2009, 6:52 pm
Looks good! Anyone can restore an old car (read JEEP),It takes a real MAN to cut one up
Roland
Roland
Posted: July 12th, 2009, 9:20 pm
Do I beat them flat wth a BFH?gunguy wrote:Looks good you'll be ready for 35's in no time. Don't forget to fold over the pinch welds they will eat your tires in nothing flat.
Posted: July 12th, 2009, 9:52 pm
yea i did mine blind i didnt tape just started cutting haha
Posted: July 12th, 2009, 9:54 pm
About time! Capndave thats how you cut up the front of a Cherokee. Tab, on the back if you cut IN BETWEEN the pinch welds you don't have to do anything with a BH, plus it looks classy. Lay some protecto trim down and you have a clean factory look.
Edit. Cut in between every hole in the body, and in turn you will still have some spot weld left, then you can line it with the protecto trim and it will look smooth like silk.
Edit. Cut in between every hole in the body, and in turn you will still have some spot weld left, then you can line it with the protecto trim and it will look smooth like silk.
Posted: July 12th, 2009, 9:57 pm
the rear on mine is done already i need to cut forward from the wheel opening to the bumper
Posted: July 12th, 2009, 11:31 pm
Yep did mine like Derek said. Works nice. Take your time and it will turn out great.
http://www.rocklizardfabrications.com/f ... imming.htm
http://www.rocklizardfabrications.com/f ... imming.htm