T-Max winch repair
Posted: April 24th, 2011, 7:47 pm
Clutch handle has a weak wedge pin. The pin breaks under minimal pressure. Here is what I found to make the repair. Remove side cover from winch. DO NOT PULL CLUTCH HANDLE OUT OF COVER
Use a 1/8 inch punch or old drill bit shank to replace pin. When you cut the pin leave it slightly shorter to allow for welding. Have pin tacked in and clean up weld then reassemble.
Use a 1/8 inch punch or old drill bit shank to replace pin. When you cut the pin leave it slightly shorter to allow for welding. Have pin tacked in and clean up weld then reassemble.
for fixin mine