Clutch handle has a weak wedge pin. The pin breaks under minimal pressure. Here is what I found to make the repair. Remove side cover from winch. DO NOT PULL CLUTCH HANDLE OUT OF COVER
Use a 1/8 inch punch or old drill bit shank to replace pin. When you cut the pin leave it slightly shorter to allow for welding. Have pin tacked in and clean up weld then reassemble.
T-Max winch repair
Moderator: Tec Team
-
Rubble
- Posts: 336
- Joined: October 29th, 2008, 9:42 pm
T-Max winch repair
You do not have the required permissions to view the files attached to this post.
03 Wrangler a few add ons
93 ZJ winter beater (sold)
93 ZJ winter beater (sold)
-
glock27
- Posts: 603
- Joined: May 16th, 2009, 10:42 pm
- Location: Elkhart
Re: T-Max winch repair
Thanx again 
for fixin mine
for fixin mine